Has a driver where you can change the DPI and there are 2 buttons + and - and if you press on it the DPI is higher or lower and now I wanted to ask if you can somehow adjust the DPI when you hold a button gets higher and when I let go again less DPI ROCCAT TYON useful for Minecraft? I have a question and I use the Roccat Kone EMP mouse and the mouse Somehow that doesn't work with the macros. So it is possible if I press the button once the button is pressed once and if I press it longer and longer. How can I assign keyboard keys to extra mouse keys?Į.g. I'm currently trying to write a macro with a roccat tyon that holds a key down, unfortunately I don't know how. I assume that there should be a similar software from Roccat. There you have the option of assigning a key press assignment to a function key on the mouse there you can enter keys or key combinations. I myself can only report about Logitech and the Logitech Options software. Does anyone know how to set this, unfortunately I haven't been able to figure it out yet.Ĭommunity expert: computers, engineering, technology I want to set this up so that when I press the key "n" is pressed until I release it again. So I want to use the side buttons on the page.
Therefore, if you notice that a new version of the ROCCAT Kone+ Mouse Driver/Firmware 1.50/1.45 driver is available, you should install it immediately.Hey, I want to assign the buttons on the side of my Roccat Tyon mouse. Manufacturers from time to time issue new versions of the ROCCAT Kone+ Mouse Driver/Firmware 1.50/1.45 software, repairing the errors they find that may cause problems with the ROCCAT devices.
Without current ROCCAT Kone+ Mouse Driver/Firmware 1.50/1.45 drivers there is a greater risk of the device malfunction, of the reduction in security, and there is a possibility of the total damage of the ROCCAT device. It is very important that the ROCCAT devices connected to your computer had their current drivers installed.
The update of the ROCCAT device driver which is not working properly After the installation of the ROCCAT Kone+ Mouse Driver/Firmware 1.50/1.45 driver, the device should work properly. Just download the ROCCAT Kone+ Mouse Driver/Firmware 1.50/1.45 driver and start the installation (keeping in mind that the ROCCAT device must be at the same time connected to the computer). This solution may seem more complicated - but it is nothing further from the truth. To make sure, disconnect now and reconnect the ROCCAT device again, and maybe this time the driver will be downloaded. It is worth noting that in order for the automatic update to work, the computer must be connected to the Internet (perhaps when connecting the ROCCAT device the computer temporarily did not have the Internet connection or a WiFi signal was weak making it impossible to download the ROCCAT Kone+ Mouse Driver/Firmware 1.50/1.45 driver).
If the "UPDATE" feature was disabled, the ROCCAT Kone+ Mouse Driver/Firmware 1.50/1.45 driver could not be installed. It is the automatic update feature that is responsible for the installation of the Keyboard & Mouse ROCCAT drivers on your computer. If this has not happened, you should take the following steps:ġ. My device has not been properly installed - what should I do?Īfter connecting a new ROCCAT device to your computer, the system should automatically install the ROCCAT Kone+ Mouse Driver/Firmware 1.50/1.45 driver.
Windows XP / Windows Vista / Windows XP 64 bit / Windows Vista 64 bit / Windows 7 / Windows 7 64 bit / Windows 8 / Windows 8 64 bit